Manufacturers Kafuter K-5203 Heat Conductive Silicone Adhesive
(Seal in LED lights, CPU, Radiator)
K-5203 is a reinforced thermally conductive silicone elastomer with great adhesion, insulation and dissipation.
Clean the surfaces by removing the rust, ash, and oil, etc.
Pierce the opening with the tip of the cap. Fix the nozzle, and coat the clean surface evenly with the adhesives, then bond the two surfaces.
The elastomer get cure with the depth of 2~4mm in 24 hours (at room temperature, 55% moisture). if the bonded parts is too deep (especially the parts not easy to contact with air) or the temperature is too low, the full cure time will be extend.
Advise users prepare enough time to let elastomer get full cure in order to keep the properties stably.
After the application, screw its nozzle tightly and store in dry and cool place for next time using.
There may be some cured gel around the opening when you use it again, just remove the cured, and use the uncured.